I. Installing Your Watch:
1. Open the watch winder’s cabin door.
2. Remove the watch pillow. During operation, press PAUSE before removal.
3. Loosen the strap: Unclasp the buckle/strap, place the watch face-up (case back down) on the pillow.
4. Secure the watch: Gently close the strap, ensuring the watch is centered, stable, and
wobble-free on the pillow. Straps should fit snugly without tension or excessive looseness
(to prevent slipping or tangling in the rotor).
5. Close the cabin door gently before starting.
II. Power Connection & On/Off:
1. Insert the power adapter’s DC plug into the winder’s power port.
2. Plug the adapter into a compatible power outlet.
3. Power ON: Press the physical power button on the unit.
4. Power OFF: Press the button again. Unplug during extended non-use.
III. Custom Winding Settings (Customizable Settings):
1. Set Rotation Direction
Use the touchscreen directional buttons to select:
* Clockwise
* Counterclockwise
* Alternating (switches direction periodically)
Alternating is recommended for 95% of watches. It mimics natural wrist motion, evenly
winds the mainspring, and protects the movement.
Always verify your watch’s recommended winding direction in its manual or with the
manufacturer.
2. Set Turns Per Day (TPD)
TPD = Total rotations completed in 24 hours (not motor rotations).
* Adjust TPD using +/- buttons, then press CONFIRM.
* Cycle logic: Runs 50 rotations → Rests 5 minutes → Repeats.
Benefits: Energy-saving, quieter operation, reduced wear, and realistic motion simulation.
TPD WARNING:
* Too high: Risk overwinding (even with modern slip-clutches).
* Too low: Insufficient power reserve.
* Consult your watch manual for brand-recommended TPD.
IV. Physical Button Customization (One-Touch Start/Stop):
1. You can assign and save the meter's settings to a physical button—press and hold
to confirm and save.
2. Press the left physical button to start the meter using your preset settings.
V.Quick Preset Modes (Pre-Optimized Presets):
1. Select pre-configured routines:
* Daily Wear (Mode 1): [Alternating rotation 300 (TPD)]
* Weekly Wear (Mode 2): [Alternating rotation 600 (TPD)]
* Rarely worn (Mode 3): [Alternating rotation 900 (TPD)]
2. Logic: Motor runs continuously until daily TPD is met → Stops → Resets after 24h.
VI. System Settings:
1. Brightness: Default 50 (adjustable in 10-step increments; range 1–100).
2. Sleep Timer: Default 1 min (options: 1/3/5/10 min or Never).
3. Time Format: 24-hour clock (auto-syncs on selection).
4. Theme: Default Serene Blue → Switch to Dynamic Red.
5. Language: Default Chinese → Switch to English.
VII. Ambient Light Control:
1. Brightness: Slide to adjust (1–100). Default ON (toggle OFF).
2. Default: Breathing effect (multi-color fade)
Custom: Toggle OFF → Select static color → Exit to apply.